Jump to content
  • Welcome!

    Welcome to BARCS forums, full of great information and ideas about your favourite hobby . Please register if you'd like to take part.

  • Who's Online   16 Members, 0 Anonymous, 24 Guests (See full list)

    • isoaritfirst
    • Lloyd_d
    • sorry
    • Peter G
    • Mark Evans
    • Steve J
    • campsieflyer
    • Andy_B
    • Marc RC pilot
    • paulorenato123
    • MAZ
    • Jess
    • Jonathan Gough
    • epler205
    • timboiow
    • Redbird
  • Upcoming Events

    No upcoming events found
  • Topics

  • Vendor Topics

  • Today's Birthdays

    No users celebrating today
  • Posts

    • Redbird
      A bicycle chain link extractor pushes the rivets out but still too large for this job. I think a pin punch is what you need though I don't have one. They have nice flat ends. You could perhaps use a ground drill bit rather than wire. 
    • oipigface
      There are two grub screws in these, and three threaded holes for them to fit in. The middle hole is to secure the pin, the other two are for the splines. Two are needed so that the screw is accessible whichever way the servo is oriented. This one is new, so there is no question of glue.  I had a look on the web for pin pushers. There seem to be two kinds. One is for pushing pins accurately into a piece of wood or board, the other for applying many tonnes of pressure to the enormous pins in caterpillar tracks. I thought there might be something like the latter (only smaller) that I could use. Otherwise it’s back to wire and hammer.
  • Member Statistics

    • Total Members
      1,535
    • Most Online
      1,037

    Newest Member
    Gliderchuck
    Joined
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.